Repair Procedures: Removal
WARNING: This page is about a different variant/trim than selected.
- Perform the line pressure removal mode off procedure by using the diagnostic tool.
- Turn ignition switch OFF and disconnect the negative (-) battery cable.
- Remove the air cleaner assembly and air duct.
(Refer to Engine Mechanical System - "AIR CLEANER ASSEMBLY ")
- Disconnect the TCM connector (A) and then loosen the TCM upper mounting bolts (B).
Tightening torque:
9.8 - 11.7 N.m (1.0 - 1.2 kgf.m, 7.2 - 8.6 lb-ft)
- Remove the engine room under cover.
(Refer to Engine Mechanical System - "ENGINE ROOM UNDER COVER ")
- Loosen the TCM connector bolt (A) and the TCM lower mounting bolts and then remove the TCM (B).
Tightening torque:
TCM lower bolt: 9.8 - 11.7 N.m (1.0 - 1.2 kgf.m, 7.2 - 8.6 lb-ft)
TCM connector bolt (A): 7.8 - 9.8 N.m (0.8 - 1.0 kgf.m, 5.7 - 7.2 lb-ft)