Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Hyundai >> 2021 >> Veloster N Standard Trans >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System Diagnosis (1 Of 3) >> DTC P0191-00: Fuel Rail Pressure Sensor Circuit Range-Performance >> DTC Information And Inspection >> DTC Detecting Condition

DTC Information And Inspection: DTC Detecting Condition

Item Detecting Condition Possible Cause
Main Action
  • Plausibility check
  1. Poor connector connection
  2. Short to Ground in Fuel Pressure Regulator Control Circuit
  3. Fuel Pressure Regulator
Prerequisite Condition
  • Engine coolant temperature (ECT) is higher than 56°C (132.8°F).
  • Full load is not active with accelerator pedal value below 90%.
  • Catalyst purge is not active.
  • Fuel trim control is functioning.
  • Catalyst overheating prevention is not active with modeled catalyst temperature below 960°C (1760°F).
  • Leakage detection is not active.
  • Engine speed is between 512 RPM and 4000 RPM.
  • Mass fuel flow is between 4mg/stroke and 60mg/stroke.
  • Canister load is lower than 0.5.
  • Volume fuel flow is between 3.1L/h to 130L/h dependent on engine speed.
  • Canister load is lower than 0.5.
Threshold value Case 1 Fuel pressure is appropriately high
  • Lambda (fuel trim) controller is higher than 25% and fuel pressure control amount is lower than -10mg.
Case 2 Fuel pressure is appropriately low
  • Lambda (fuel trim) controller is lower than -20% and fuel pressure control amount is higher than 13mg.
Diagnostic Time
  • 8 Seconds
MIL On Condition
  • 3rd Driving Cycle