Component Inspection: Specification
| Temp. (°C) | Resistance (kΩ) | Temp. (°C/°F) | Resistance (kΩ) |
|---|---|---|---|
| -40/-40 | 48.14 | 20/68 | 1.15 |
| -20/-4 | 14.13 ~ 16.83 | 40/104 | 0.59 |
| 0/32 | 5.79 | 60/140 | 0.32 |
| 10/50 | 2.31 ~2.59 |
- Is the measured resistance within specification?
YES
- Clear DTC and test-drive under the Prerequisite Condition. After the road test, if this DTC is set, recheck resistance. If not, it is intermittent fault. Go to "Verification Of Repair "
NO
- Check ECTS for contamination, deterioration, or damage. Substitute with a known-good ECTS and check for proper operation. If the problem is corrected, replace ECTS and then Go to "Verification Of Repair " procedure.