Terminal and Connection Inspection
- Disconnect the Cruise Remocon Switch and PCM connectors and inspect for looseness, poor connection, bending, corrosion, contamination, deterioration or damage. Reconnect the connectors.
- Connect the GDS and go to "Current Data".
- Monitor CRUISE REMOCON SWITCH values in Current Data, check and wiggle the harness(es), connector(s), and terminal(s).
- Any change in the values indicates a poor connection. Was a connector problem found?
YES
- Repair the connector. Go to "Verification Of Vehicle Repair " procedure.
NO
- Go to "Power Circuit Inspection" procedure.
| Check Item | Specifications | Check Condition | Terminal (+) | Terminal (-) |
|---|---|---|---|---|
| Power Circuit - Voltage | 11.5V~13.0V | Ignition SW "ON" | Cruise Main terminal of "CRUISE REMOCON SWITCH" Harness | Chassis GND |
- Is resistance within specification?
YES
- Go to "Signal Circuit Inspection" procedure.
NO
- Repair short to ground/open between 'CRUISE MAIN' terminal of 'CRUISE REMOCON SWITCH' harness connector and 'Cruise supply' terminal of PCM harness connector, and go to "Verification Of Vehicle Repair " procedure.
| Check Item | Specifications | Check Condition | Terminal (+) | Terminal (-) |
|---|---|---|---|---|
| Signal Circuit - Voltage | 4.8V~5.1V | Ignition SW "ON" | Cruise signal terminal of "CRUISE REMOCON SWITCH" Harness | Chassis GND |
- Is voltage within specification?
YES
- Go to "Signal Circuit for Short" procedure.
NO
- Go to "Check short in signal circuit" as follows.
| Check Item | Specifications | Check Condition | Terminal (+) | Terminal (-) |
|---|---|---|---|---|
| Signal Circuit for Short - Resistance | Infinite | Ignition SW "OFF" | Cruise signal terminal of "CRUISE REMOCON SWITCH" Harness | Cruise Main terminal of "CRUISE REMOCON SWITCH" Harness |
| Cruise signal terminal of "CRUISE REMOCON SWITCH" Harness | GND terminal of "CRUISE REMOCON SWITCH" Harness |
- Is the measured value within specification?
YES
- Go to "Signal Circuit for Open" procedure.
NO
- Repair short in signal circuit, and go to "Verification Of Vehicle Repair " procedure.
| Check Item | Specifications | Check Condition | Terminal (+) | Terminal (-) |
|---|---|---|---|---|
| Signal Circuit for Open - Resistance | Below 1.0Ω | Ignition SW "OFF" | Cruise signal terminal of "CRUISE REMOCON SWITCH" Harness | Cruise signal terminal of PCM Connector |
- Is the measured value within specification?
YES
- Go to "COMPONENT INSPECTION " procedure below.
NO
- Repair open between 'Signal (Cruise sw)' terminal of 'CRUISE REMOCON SWITCH' harness connector and 'Signal (Cruise sw)' terminal of PCM connector, and go to "Verification Of Vehicle Repair " procedure.