Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Hyundai >> 2021 >> Tucson Value, FWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 17 (Engine Starting System - 2.4L) >> Starter >> Repair Procedures >> Disassembly

Repair Procedures: Disassembly

WARNING: This page is about a different variant/trim than selected.
  1. Disconnect the M-terminal (A) on the magnet switch assembly (B).
    G13034221Courtesy of HYUNDAI MOTOR AMERICA
  2. After loosening the screws (A), detach the magnet switch assembly (B).
    G13034222Courtesy of HYUNDAI MOTOR AMERICA
  3. Loosen the through bolts (A).
    G13034223Courtesy of HYUNDAI MOTOR AMERICA
  4. Remove the brush holder assembly (A), yoke (B) and armature (C).
    G13034224Courtesy of HYUNDAI MOTOR AMERICA
  5. Remove the lever plate (B) and lever packing (A).
    G13034225Courtesy of HYUNDAI MOTOR AMERICA
  6. Remove the packing (A) and shield (B).
    G13034226Courtesy of HYUNDAI MOTOR AMERICA
  7. Disconnect the planet gear (A).
    G13034227Courtesy of HYUNDAI MOTOR AMERICA
  8. Disconnect the planet shaft assembly (or reducer assembly) (A) and lever (B).
    G13034228Courtesy of HYUNDAI MOTOR AMERICA
  9. Press the stopper (A) using a socket (B).
    G13034229Courtesy of HYUNDAI MOTOR AMERICA
  10. After removing the stop ring (A) using stop ring pliers (B).
    G13034230Courtesy of HYUNDAI MOTOR AMERICA
  11. Disconnect the stopper (A), overrunning clutch (B), internal gear (C), planet shaft (D) and/or gasket sheet (E).
    G13034231Courtesy of HYUNDAI MOTOR AMERICA
  12. Reassembly is the reverse of disassembly.
    NOTE:
    • Using a suitable pulling tool (A), pull the overrunning clutch stopper (C) over the stop ring (B).
    G13034232Courtesy of HYUNDAI MOTOR AMERICA
scientia non olet · About Mike's Workshop Manuals