Repair Procedures: Removal
WARNING: This page is about a different variant/trim than selected.
Information
- Accelerator Position Sensor (APS) cannot be replaced on its own, it should be replaced with accelerator pedal assembly.
- Turn the ignition switch OFF and disconnect the negative (-) battery cable.
- Disconnect the accelerator position sensor connector (A).
- Remove the mounting cap (A).
- Remove the accelerator pedal assembly after loosening the mounting bolt & nut (A).
Tightening Torque:
8.8 - 13.7 N.m (0.9 - 1.4 kgf.m, 6.5 - 10.1 lb.ft)