Repair Procedures: Installation
WARNING: This page is about a different car, the 2022 Hyundai Santa Fe. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
- Install the component with the specified torques.
- Note that internal damage may occur when the component is dropped. If the component has been dropped, inspect before installing.
- Insert the sensor in the installation hole and be careful not to damage.
- Apply the engine coolant to the O-ring (A).
[ITM Side]
[Water Pump Side]
[Cylinder Block Side]
- Do not reuse the fixing clip (A).
- Install in the reverse order of removal.
- Supplement the engine coolant.
(Refer to Engine Mechanical System - "COOLANT ")