Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Hyundai >> 2020 >> Elantra Value Edition >> Repair and Diagnosis >> External Pages >> Different car >> Section 18 (Airbag Modules And Clock Spring) >> Knee Airbag (KAB) Module >> Repair Procedures >> Installation

Repair Procedures: Installation

WARNING: This page is about a different car, the 2019 Hyundai Elantra. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the ignition key from the vehicle.
  2. Disconnect the battery negative cable and wait for at least three minutes.
  3. Install the knee airbag module after connect the knee airbag module connector.

    Tightening torque  :

    Bolt: 7.8 ~ 11.8 N.m (0.8 ~ 1.2 kgf.m, 5.8 ~ 8.7 lb-ft)

  4. Install the crash pad lower panel.
  5. Reconnect the battery negative cable.
  6. After installing the knee airbag (KAB), confirm proper system operation:
    • Turn the ignition switch ON; the SRS indicator light should be turned on for about six seconds and then go off.
scientia non olet · About Mike's Workshop Manuals