Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Hyundai >> 2020 >> Elantra Value Edition >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System Diagnosis - 2.0L (5 Of 6) >> DTC P0620-00: Alternator Control Circuit >> Component Inspection >> PCM check

PCM check

  1. IG "OFF".
  2. Select "vehicle scopemeter" in the menu, and connect channel A of GDS with FR terminal of Alternator harness connector.
  3. Connect Channel B of GDS with C terminal of Alternator harness connector.
  4. Engine start. And check the signal waveforms. (Compare the signal waveform of electrical loads ON with OFF)

    Specification:  Refer to SIGNAL WAVEFORM AND DATA 

  5. Is the measured signal waveforms of Alternator normal?

    YES 

    NO 

    • Substitute with a known - good PCM and check for proper operation. If the problem is corrected, replace PCM and go to "VERIFICATION OF VEHICLE REPAIR " procedure.
scientia non olet · About Mike's Workshop Manuals