Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Hyundai >> 2019 >> Santa Fe SEL Plus, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 69 (Electronic Stability Program (Esp) System) >> ESP Control Module >> Repair Procedures >> Installation

Repair Procedures: Installation

WARNING: This page is about a different car, the 2020 Hyundai Santa Fe. However, it is still accessible from the selected car via links, so may be relevant.
  1. To install, reverse the removal procedure.
  2. After installation, bleed the brake system.

    (Refer to BRAKE BLEEDING PROCEDURES )

  3. Connect the GDS to the data link connector located underneath the dash panel.
  4. Conduct the Variant coding.
  5. Conduct the Auto Detected Sensor Calibration.
  6. Conduct the Longitudinal G Sensor Calibration.
  7. After replacing the ESP control module execute the "Assembly Check (ECU replacement)" of the additional function to check that the mounting is successful.
scientia non olet · About Mike's Workshop Manuals