Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Hyundai >> 2019 >> Santa Fe SEL Plus, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 18 (Engine Control System - 2.0L) >> Accelerator Position Sensor (APS) >> Repair Procedures >> Removal

Repair Procedures: Removal

WARNING: This page is about a different car, the 2020 Hyundai Santa Fe. However, it is still accessible from the selected car via links, so may be relevant.
  1. Turn the ignition switch OFF and disconnect the negative (-) battery terminal.
  2. Disconnect the accelerator position sensor connector (A).
  3. Remove the upper mounting cap (B), and then remove the mounting nut (C).
  4. Remove the lower mounting cap (D), and then remove the mounting nut (E).
    G12991970Courtesy of HYUNDAI MOTOR AMERICA
    G12991971Courtesy of HYUNDAI MOTOR AMERICA
scientia non olet · About Mike's Workshop Manuals