Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Hyundai >> 2018 >> Tucson Value, FWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 35 (Engine Control System - 2.0L) >> Accelerator Position Sensor (APS) >> Repair Procedures >> Removal

Repair Procedures: Removal

WARNING: This page is about a different variant/trim than selected.
  1. Turn the ignition switch OFF and disconnect the negative (-) battery cable
  2. Disconnect the accelerator position sensor connector (A)
  3. Remove the installation bolt (B), the nuts (C) and then remove the accelerator pedal module.
    G12610919Courtesy of HYUNDAI MOTOR AMERICA
scientia non olet · About Mike's Workshop Manuals