Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Hyundai >> 2018 >> Santa Fe XL Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 69 (Smart Key Code Saving (Button) System Diagnosis) >> DTC P1696: Immobilizer-Authentication Fail >> Verification Of Repair >> Verification Of Vehicle Repair

Verification Of Vehicle Repair

WARNING: This page is about a different car, the 2017 Hyundai Santa Fe XL and 2017 Hyundai Santa Fe. However, it is still accessible from the selected car via links, so may be relevant.

After a repair, it is essential to verify that the fault has been corrected.

  1. Connect GDS and check "PCM status and Smartkey PCM status, which is in the IPM"
  2. Select "Diagnostic Trouble Codes (DTC)  " mode and then clear DTC.
  3. Operate the vehicle within the enable condition and monitor the DTC on the GDS.
  4. Are any DTCs present?

    YES 

    • Go to the applicable troubleshooting procedure.

    NO 

    • System is performing to specification at this time.
scientia non olet · About Mike's Workshop Manuals