Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Hyundai >> 2018 >> Santa Fe XL Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 69 (Smart Key Code Saving (Button) System Diagnosis) >> DTC P1676: Immobilizer-Smartra Message Error >> Verification Of Repair >> Verification Of Vehicle Repair

Verification Of Vehicle Repair

WARNING: This page is about a different car, the 2017 Hyundai Santa Fe XL and 2017 Hyundai Santa Fe. However, it is still accessible from the selected car via links, so may be relevant.

After a repair, it is essential to verify that the fault has been corrected.

  1. Connect GDS and check "No. of Key learnt, PCM status and Smartkey PCM status".
  2. Select "Diagnostic Trouble Codes (DTC)  " mode and then clear DTC.
  3. Operate the vehicle within the enable condition and monitor the DTC on the GDS.
  4. Are any DTCs present?

    YES 

    • Go to the applicable troubleshooting procedure.

    NO 

    • System is performing to specification at this time.
scientia non olet · About Mike's Workshop Manuals