Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Hyundai >> 2018 >> Santa Fe XL Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 55 (Supplemental Restraint System Control Module (SRSCM) And Sensors) >> Passive Occupant Detection System (PODS-F) >> Repair Procedures >> Installation >> PODS-F Mat

PODS-F Mat

WARNING: This page is about a different car, the 2017 Hyundai Santa Fe XL and 2017 Hyundai Santa Fe. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the PODS-F Mat equipped seat cushion assembly on the front seat assembly.

    (Refer to  FRONT SEAT ASSEMBLY  ) 

  2. Connect the PODS-F mat connector.
  3. Install the front passenger seat assembly.

    (Refer to  FRONT SEAT ASSEMBLY  ) 

  4. Reconnect the battery negative cable.
  5. After installing the PODS-F, confirm proper system operation:
    • Turn the ignition switch ON the SRS indicator should be turned on for about six seconds and then go off.
    • Telltale lamp will turn on for 4 seconds and be turned off for 3 seconds. After the 7 seconds, it shall remain off if the PODS-F does not require suppression and the passenger airbag is enabled.
    NOTE: Be sure to perform PODS-F zeroing with GDS after replacing PODS-F equipped seat cushion.
scientia non olet · About Mike's Workshop Manuals