Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Hyundai >> 2018 >> Santa Fe SE, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 20 (Airbag Modules And Clock Spring) >> Knee Airbag (KAB) Module >> Repair Procedures >> Installation

Repair Procedures: Installation

WARNING: This page is about a different car, the 2017 Hyundai Santa Fe XL and 2017 Hyundai Santa Fe. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the ignition key from the vehicle.
  2. Disconnect the battery negative cable and wait for at least three minutes.
  3. Connect the knee airbag connector.
  4. Tighten the knee airbag mounting nuts.

    Tightening torque: 

    7.8 ~ 11.8 N.m (0.8 ~ 1.2 kgf.m, 5.8 ~ 8.7 lb-ft)

  5. Install the crash pad lower panel.

    (Refer to " CRASH PAD LOWER PANEL  ") 

  6. Install the crash pad side cover.

    (Refer to " CRASH PAD SIDE COVER  ") 

  7. Reconnect the battery negative cable.
  8. After installing the knee airbag, confirm proper system operation:
    • Turn the ignition switch ON; the SRS indicator light should be turned on for about six seconds and then go off.
scientia non olet · About Mike's Workshop Manuals