DTC Information: DTC Detecting Condition

Item		Detecting Condition	Possible Cause
Case 1	DTC Strategy	O2 sensor controller malfunction	Poor connection or damaged harness Unstable Power Faulty PCM
	Enable Conditions	Ignition "ON" Battery voltage is between 10V and 16V.
	Threshold value	Error bit information from H/W circuit
	Diagnosis Time	5 seconds
Case 2	DTC Strategy	Knock acquisition check
	Enable Conditions	Engine speed is higher than 32 RPM.
	Threshold value	Integrity of the knock acquisition is not correct.
	Diagnosis Time	200 revs
Case 3	DTC Strategy	Power stage Port Flap Driver over temperature
	Enable Conditions	Battery voltage is between 10V and 16V. Engine speed is higher than 32 RPM.
	Threshold value	Power stage output for Port Flap has over temperature.
	Diagnosis Time	0.4 seconds
Case 4	DTC Strategy	H-bridge (ETC, Port Flap) malfunction
	Enable Conditions	Ignition "ON"
	Threshold value	Micro-controller communication error is detected.
	Diagnosis Time	1 second
Case 5	DTC Strategy	Output driver malfunction
	Enable Conditions	Ignition "ON"
	Threshold value	Micro-controller communication error is detected.
	Diagnosis Time	1 second
MIL On Condition		2 Driving Cycles
Case 6	DTC Strategy	Power Relay driver malfunction
	Enable Conditions	Ignition "ON"
	Threshold value	Micro-controller communication error is detected.
	Diagnosis Time	1 second
Case 7	DTC Strategy	5V power supply driver malfunction
	Enable Conditions	Ignition "ON"
	Threshold value	Micro-controller communication error is detected.
	Diagnosis Time	1 second
MIL On Condition		2 Driving Cycles