Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Hyundai >> 2018 >> Elantra SE, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 254 (Blind Spot Detection System) >> Blind Spot Detection Unit >> Repair Procedures >> Installation

Repair Procedures: Installation

WARNING: This page is about a different car, the 2017 Hyundai Elantra. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the BSD unit and bracket.

    Tightening torque: 

    BSD bracket: 3.9 - 5.9 N.m (0.4 - 0.6 kg cm, 2.9 - 4.4 lb-ft)

    BSD unit: 3.92 ± 0.98 N.m

  2. Install the rear bumper.
  3. Connect the negative (-) battery terminal.
    NOTE:
    • Take care not to confuse left side (master) and right side (slave) unit when installing.
    • BSD units connector connect to the wiring connector.
scientia non olet · About Mike's Workshop Manuals