Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Hyundai >> 2018 >> Elantra GT Base, Automatic Trans >> Repair and Diagnosis >> Accessories & Equipment >> Drivers Assistance Systems - ADAS >> Blind Spot Detection System >> Blind Spot Detection Unit >> Repair Procedures >> Installation

Repair Procedures: Installation

  1. Install the BSD Unit and Bracket.

    Tightening Torque: 

    BSD Bracket: 3.9 - 5.9 N.m (0.4 - 0.6 kg cm, 2.9 - 4.4 lb-ft)

    BSD unit: 3.92 ± 0.105 N.m

  2. Install the rear bumper.
  3. Connect the negative (-) battery terminal.
    NOTE:
    • Take care not to confuse left side (master) and right side (slave) unit when installing.
    • BSD units connector connect to the wiring connector.
scientia non olet · About Mike's Workshop Manuals