Ignition system check

Turn the ignition switch "OFF".
Disconnect Ignition coil connector.
Do visual inspection.
- Check contamination or damage on ignition coil.
Turn the ignition switch "ON" & ENG "OFF".
Measure the voltage between Power, Control, Ground terminal of ignition coil harness connector and chassis ground.
Specification :

Power Terminal Approx. Battery Voltage

Control Terminal Approx. 0V
Is the measured voltage within specifications?
YES
- Go to "Timing mark check ".
NO
- Repair Open or Short to ground in power circuit, and go to "Verification of Vehicle Repair ".