Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Hyundai >> 2018 >> Accent SE, Automatic Trans >> Repair and Diagnosis >> Brakes >> Traction Control >> Antilock Brake System/Electronic Stability Control System Diagnosis >> DTC C1260-02: Steering Angle Sensor Circuit-Signal >> DTC Inspection >> Monitor GDS Data

Monitor GDS Data

  1. Turn "ON" the ignition switch.
  2. Connect GDS to Data Link Connector (DLC).
  3. Turn the steering wheel to the left and right.
  4. Monitor the "Steering Angle Sensor (CAN) (ESP Only)" parameter on the "Current Data" menu of the GDS.

    Specification  :

    The difference between the maximum and minimum value is less than 50 DEG. Also, the value should fluctuate smoothly.

    G12593381Courtesy of HYUNDAI MOTOR AMERICA
  5. When steering wheel is turned, is the parameter changed?

    YES 

    • Fault can be caused when ESP (ESC) memory was not cleared after it was repaired. Clear the DTC and go to "Verification of Vehicle Repair " procedure.

    NO 

    • Go to next step.
scientia non olet · About Mike's Workshop Manuals