Repair Procedures: Installation

NOTE: Before installing, check that the shift lever in the "N" position.

Install the shift lever assembly (A).
Tightening torque:

9.8 ~ 13.7 N.m (1.0 ~ 1.4 kgf.m, 7.2 ~ 10.1 lb-ft)

Fig 1: Installing Shift Lever Assembly
Courtesy of HYUNDAI MOTOR AMERICA
Install the shift cable (A).
NOTE: Insert the shift cable after checking the direction of projection (B) to prevent wrong assembly.

Fig 2: Installing Shift Cable
Courtesy of HYUNDAI MOTOR AMERICA
Connect the main connector (A).

Fig 3: Connecting Main Connector
Courtesy of HYUNDAI MOTOR AMERICA
Install the floor console assembly.
(Refer to "Floor Console ")
Install the shift lever knob assembly.
1. Install the knob assembly (A) and then fixing the pin (B).
  
  Fig 4: Installing Shift Lever Knob Assembly
  Courtesy of HYUNDAI MOTOR AMERICA
2. Install the cover (A).
  
  Fig 5: Installing Cover
  Courtesy of HYUNDAI MOTOR AMERICA
  
  CAUTION: Check that operating surely at each range of the inhibitor switch corresponding to each position of shift lever.