Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Hyundai >> 2017 >> Veloster Turbo, Automatic DCT Trans >> Repair and Diagnosis >> Transmission >> Transmission Control Systems >> Dual Clutch Transmission Control System - 1.6L T-GDI >> Input Shaft Speed Sensor 1 >> Repair Procedures >> Removal

Repair Procedures: Removal

  1. Remove the air cleaner assembly and air duct.

    (Refer to "AIR CLEANER ")

  2. Remove the battery and tray.

    (Refer to "BATTERY ")

  3. Remove the ECM.

    (Refer to "ECM ")

  4. Remove the clutch actuator assembly.

    (Refer to Dual Clutch Transmission Control System - "CLUTCH ACTUATOR ASSEMBLY ")

  5. Disconnect the input shaft speed sensor (A).
    Fig 1: Disconnecting Input Shaft Speed Sensor
    G12125084Courtesy of HYUNDAI MOTOR AMERICA
  6. Remove the input shaft speed sensor after removing the bolt (A-2ea).
    Fig 2: Locating Input Shaft Speed Sensor Bolt
    G12125085Courtesy of HYUNDAI MOTOR AMERICA
    Fig 3: Input Shaft Speed Sensor 1
    G12125086Courtesy of HYUNDAI MOTOR AMERICA
scientia non olet · About Mike's Workshop Manuals