Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Hyundai >> 2017 >> Veloster Turbo, Automatic DCT Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 18 (Engine Control System - 1.6L GDI) >> ETC (Electronic Throttle Control) System >> Repair Procedures >> Removal

Repair Procedures: Removal

WARNING: This page is about a different variant/trim than selected.
  1. Turn the ignition switch OFF and disconnect the battery negative (-) cable.
  2. Remove the resonator and the air intake hose.

    (Refer to REMOVAL (STEP 3) )

  3. Disconnect the ETC module connector (A).
    Fig 1: Locating ETC Module Connector
    G12129392Courtesy of HYUNDAI MOTOR AMERICA
  4. Remove the installation bolts, and then remove the ETC module (A) from the engine.
    Fig 2: Locating ETC Module With Installation Bolts
    G12129393Courtesy of HYUNDAI MOTOR AMERICA
scientia non olet · About Mike's Workshop Manuals