PODS-F Zeroing Procedure

You should perform PODS-F Re-zero procedure after service or replacement about all part of the passenger seat. (Not included full seat assembly)

1. Ignition "OFF", connect GDS.
2. Ignition "ON" & Engine "OFF", select Airbag system and "PODS-F Reset" mode.
   Fig 1: Screen Display - PODS-F Reset Mode

   Courtesy of HYUNDAI MOTOR AMERICA
3. The GDS will show the two PODS-F Zeroing function steps.
   1. Erase PODS-F diagnostic codes.
   2. PODS-F initialization.
   Fig 2: Screen Display - PODS-F Initialization

   Courtesy of HYUNDAI MOTOR AMERICA
   CAUTION: This step must be done PODS-F re-zero, when the front passenger seat is empty.
4. The PODS-F initialization procedure will be performed.

Fig 3: Screen Display - PODS-F Initialization (1 Of 2)

Courtesy of HYUNDAI MOTOR AMERICA

Fig 4: Screen Display - PODS-F Initialization Completed (2 Of 2)

Courtesy of HYUNDAI MOTOR AMERICA