Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Hyundai >> 2017 >> Veloster Base, Standard Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 9 (Charging System - 1.6L T-GDI) >> Alternator >> Repair Procedures >> Removal

Repair Procedures: Removal

WARNING: This page is about a different variant/trim than selected.
  1. Disconnect the battery negative terminal.
  2. Loosen the mounting bolts (A) and then, turn the adjusting bolt (B) clockwise to loosen tension.
    Fig 1: Locating Tension Adjusting Bolt And Mounting Bolts
    G12124625Courtesy of HYUNDAI MOTOR AMERICA
  3. Remove the drive belt (A).
    Fig 2: Locating Drive Belt
    G12124626Courtesy of HYUNDAI MOTOR AMERICA
  4. Disconnect the air compressor connector (A) and the alternator connector (B), and remove the cable from alternator "B" terminal (C).
    Fig 3: Locating Air Compressor Connector, Alternator Connector & Alternator B Terminal
    G12124627Courtesy of HYUNDAI MOTOR AMERICA
  5. Remove the alternator (A).
    Fig 4: Locating Alternator With Bolts
    G12124628Courtesy of HYUNDAI MOTOR AMERICA
scientia non olet · About Mike's Workshop Manuals