Removal And Installation

WARNING: This page is about a different variant/trim than selected.

Loosen the drain plug, and drain the engine coolant. Remove the radiator cap to drain with speed.
Disconnect the battery negative terminal.
Remove the air cleaner assembly.
(Refer to "AIR CLEANER ")
Disconnect the water temperature sensor connector (A).
Disconnect the radiator upper hose (B).
Remove the heater hose (C).
Disconnect the water hose (D).

Fig 1: Locating Water Temperature Sensor Connector, Radiator Upper Hose, Heater Hose & Water Hose
Courtesy of HYUNDAI MOTOR AMERICA
Remove the water temperature control assembly (B).
Tightening torque:

9.8 ~ 11.7 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)

Fig 2: Removing Water Temperature Control Assembly With Bolts
Courtesy of HYUNDAI MOTOR AMERICA
Install in the reverse order of removal.
CAUTION: Clean the surface of the water temperature control assembly before installing.