Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Hyundai >> 2017 >> Veloster Base, Standard Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 6 (Engine Cooling System - 1.6L T-GDI) >> Radiator >> Repair Procedures >> Inspection >> Radiator Cap Testing

Radiator Cap Testing

WARNING: This page is about a different variant/trim than selected.
  1. Remove the radiator cap, wet its seal with engine coolant, and then install it on a pressure tester.
    Fig 1: Testing Radiator Cap
    G12124392Courtesy of HYUNDAI MOTOR AMERICA
  2. Apply a pressure of 93.16~122.58kpa (0.95~1.25kg/cm2 , 13.51~17.78psi).
  3. Check for a drop in pressure.
  4. If the pressure drops, replace the cap.
scientia non olet · About Mike's Workshop Manuals