Repair Procedures: Disassembly

WARNING: This page is about a different variant/trim than selected.

Disconnect the M-terminal (A) on the magnet switch assembly.

Fig 1: Disconnecting M-Terminal
Courtesy of HYUNDAI MOTOR AMERICA
After loosening the 2 screws (A), detach the magnet switch assembly (B).

Fig 2: Loosening Magnet Switch Assembly And Screws
Courtesy of HYUNDAI MOTOR AMERICA
Loosen the brush holder mounting screw (A) and the trough bolts (B).

Fig 3: Locating Brush Holder Mounting Screw & Trough Bolts
Courtesy of HYUNDAI MOTOR AMERICA
Remove the rear bracket (A) and brush holder assembly (B).

Fig 4: Locating Rear Bracket & Brush Holder Assembly
Courtesy of HYUNDAI MOTOR AMERICA
Remove the yoke (A).

Fig 5: Locating Yoke
Courtesy of HYUNDAI MOTOR AMERICA
Remove the packing (A), lever plate (B), lever (C), armature (D).

Fig 6: Locating Packing, Lever Plate, Lever And Armature
Courtesy of HYUNDAI MOTOR AMERICA
Press the stopper (A) using a socket (B).

Fig 7: Pressing Stopper Using A Socket
Courtesy of HYUNDAI MOTOR AMERICA
After removing the stop ring (A) using stopper pliers (B).

Fig 8: Removing Stop Ring Using Stopper Pliers
Courtesy of HYUNDAI MOTOR AMERICA
Remove the stop ring (B), stopper (A), overrunning clutch (C) and armature (D).

Fig 9: Locating Stop Ring, Stopper, Over Running Clutch & Armature
Courtesy of HYUNDAI MOTOR AMERICA
IMPORTANT:
- Using a suitable pulling tool (A), pull the overrunning clutch stopper (C) over the stop ring (B).
Fig 10: Pulling On Overrunning Clutch Stopper Using Suitable Pulling Tool
Courtesy of HYUNDAI MOTOR AMERICA