Repair Procedures: Disassembly

WARNING: This page is about a different variant/trim than selected.

Remove the cover (A).

Fig 1: Removing Cover
Courtesy of HYUNDAI MOTOR AMERICA
Remove the bracket (A) after loosening the screw (B).

Fig 2: Removing Bracket Screw
Courtesy of HYUNDAI MOTOR AMERICA
Disconnect the "P" position switch (A).

Fig 3: Disconnecting P Position Switch
Courtesy of HYUNDAI MOTOR AMERICA
Disconnect the shift lock solenoid (A).

Fig 4: Disconnecting Shift Lock Solenoid
Courtesy of HYUNDAI MOTOR AMERICA
Disconnect the manual mode switch housing (A).

Fig 5: Disconnecting Manual Mode Switch Housing
Courtesy of HYUNDAI MOTOR AMERICA
Disconnect the main connector (A) from the shift lever.

Fig 6: Disconnecting Main Connector From Shift Lever
Courtesy of HYUNDAI MOTOR AMERICA
Remove the pin fixing bracket (A) from the main connector.

Fig 7: Removing Pin Fixing Bracket From Main Connector
Courtesy of HYUNDAI MOTOR AMERICA
Remove each terminals (F) of the P position switch (A), shift lock solenoid (B), manual mode switch housing (C) after released lock (E) from the main connector (D).
CAUTION: Record the location of the wiring colors before disconnecting the terminals.

Fig 8: Wiring Colors Location
Courtesy of HYUNDAI MOTOR AMERICA

Fig 9: Locating P Position Switch, Shift Lock Solenoid, Manual Mode Switch Housing Terminals
Courtesy of HYUNDAI MOTOR AMERICA
- Connector information
Fig 10: Shift Lever Connector Terminals
Courtesy of HYUNDAI MOTOR AMERICA
1. DCT sensor_IG 1
2. DCT_sensor_ground
3. CAN (High)
4. "P" Position switch (+)
5. "P" Position switch (-)
6. CAN (Low)
7. Sport mode down switch
8. Sport mode select switch
9. Sport mode up switch
10. Up/Down & select swtich ground
11. Shift lock solenoid (+)
12. Shift lock solenoid (-)