Repair Procedures: Removal

Remove the following parts first:
- Air cleaner assembly and air duct
  (Refer to ENGINE AND TRANSAXLE ASSEMBLY .)
- Battery and tray
  (Refer to BATTERY .)
- ECM (Refer to ENGINE CONTROL MODULE (ECM) .)
NOTE: Place the gear shift lever and manual control lever to the N position when performing maintenance on the inhibitor switch.
Disconnect the inhibitor switch connector (A).

Fig 1: Locating Inhibitor Switch Connector
Courtesy of HYUNDAI MOTOR AMERICA
Remove the shift cable mounting nut (A).

Fig 2: Locating Shift Cable Mounting Nut
Courtesy of HYUNDAI MOTOR AMERICA
Loosen the nut (A), and then remove the manual control lever (B).
Loosen the mounting bolt, and then remove the inhibitor switch (C).

Fig 3: Locating Inhibitor Switch, Manual Control Lever And Nut
Courtesy of HYUNDAI MOTOR AMERICA