Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Hyundai >> 2017 >> Veloster Base, Automatic DCT Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 18 (Manual Transaxle System - 1.6L T-GDI) >> Back-Up Lamp Switch >> Repair Procedures >> Inspection

Repair Procedures: Inspection

WARNING: This page is about a different variant/trim than selected.
  1. Remove the following items.
    1. Air cleaner assembly

      (Refer to "AIR CLEANER ")

    2. Battery and battery tray

      (Refer to "BATTERY ")

  2. Disconnect the back up lamp switch connector (A).
    Fig 1: Disconnecting Back Up Lamp Switch Connector
    G12124968Courtesy of HYUNDAI MOTOR AMERICA
  3. Check the continuity between no. 1 and 2 terminals of backup lamp switch. When the shift lever is in reverse, there should be continuity.
    Fig 2: Checking Continuity Between No. 1 & 2 Terminals Of Backup Lamp Switch
    G12124969Courtesy of HYUNDAI MOTOR AMERICA
scientia non olet · About Mike's Workshop Manuals