Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Hyundai >> 2017 >> Tucson Value, FWD >> Repair and Diagnosis >> Restraints >> Air Bag, SRS >> Supplemental Restraint System Control Module (SRSCM) And Sensors >> Occupant Classification System (OCS) >> Repair Procedures >> Installation >> OCS Ecu

OCS Ecu

  1. Install the occupant classification system unit on the Front seat track assembly.
    Fig 1: Installing Occupant Classification System Unit On Front Seat Track Assembly
    G12041382Courtesy of HYUNDAI MOTOR AMERICA
  2. Connect the occupant classification system unit connector.
    Fig 2: Connecting Occupant Classification System Unit Connector
    G12041383Courtesy of HYUNDAI MOTOR AMERICA
  3. Install the front passenger seat assembly.

    (Refer to Body - "FRONT SEAT ASSEMBLY ")

  4. Reconnect the battery negative cable.
  5. After installing the occupant classification system, confirm proper system operation.
NOTE:
  • Turn the ignition switch ON the SRS indicator should be turned on for about six seconds and then go off.
  • Telltale lamp will turn on for 4 seconds and be turned off for 3 seconds. After the 7 seconds, it shall remain off if the OCS does not require suppression and the passenger airbag is enabled.
  • Be sure to perform OCS zeroing with GDS after replacing OCS equipped seat cushion.
scientia non olet · About Mike's Workshop Manuals