Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Hyundai >> 2017 >> Tucson Value, FWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 34 (4WD Control System Diagnosis) >> DTC P1836: Bleed Pressure Line Test Error >> Component Inspection

Component Inspection

WARNING: This page is about a different variant/trim than selected.

■ Actuator Test Check 

  1. Connect scantool to Data Link Connector (DLC)
  2. IG key "ON"
  3. Perform "Actuation Test" with scantool.
    Fig 1: Scantool Display - Current Data And Actuation Test
    G12047705Courtesy of HYUNDAI MOTOR AMERICA
  4. Are any DTCs present?

    YES 

    • Substitute with a known-good "Coupling" and check for proper operation. If the problem is corrected, replace "Coupling" and then go to "Verification of Vehicle Repair " procedure.

    NO 

scientia non olet · About Mike's Workshop Manuals