Repair Procedures: Removal

Disconnect the negative (-) battery terminal.
Remove the rear bumper.
(Refer to Body - "REAR BUMPER ")
Remove the BSD unit (A) after loosening the mounting nuts.

Fig 1: Removing BSD Unit (1 Of 2)
Courtesy of HYUNDAI MOTOR AMERICA

Fig 2: Removing BSD Unit (2 Of 2)
Courtesy of HYUNDAI MOTOR AMERICA
NOTE:
- Take care not to separate the bracket from rear bumper when removing the BSD sensor.
Replace the bracket (A) when the bracket is physically changed or damaged.

Fig 3: Replacing Bracket
Courtesy of HYUNDAI MOTOR AMERICA
CAUTION:
- Radar does not work normally if the bracket is physically changed or damaged.
Replace the extension wiring (A) when it damaged.

Fig 4: Replacing Extension Wiring

G12043234

Courtesy of HYUNDAI MOTOR AMERICA