Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Hyundai >> 2017 >> Sonata Base >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 55 (Airbag Modules And Clock Spring (HEV)) >> Side Airbag (SAB) Module >> Repair Procedures >> Installation

Repair Procedures: Installation

WARNING: This page is about a different variant/trim than selected.
CAUTION:
  • Be sure to install the harness wires so they will not pinch or interfere with other parts.
NOTE:
  • Do not open the lid of the side airbag cover.
  • Make sure that the airbag assembly cover is installed properly. Improper installation may prevent the proper deployment.
  1. Remove the ignition key from the vehicle.
  2. Disconnect the battery negative cable and wait for at least three minutes.
  3. Install the new seat back assembly.

    (Refer to "FRONT SEAT BACK COVER ")

  4. Install the front seat assembly.

    (Refer to "FRONT SEAT ASSEMBLY ")

  5. Recline and slide the front seat forward fully, make sure the harness wires are not pinched of interfere with other parts.
  6. Reconnect the battery negative cable.
  7. After installing the side airbag (SAB), confirm proper system operation:
scientia non olet · About Mike's Workshop Manuals