Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Hyundai >> 2017 >> Sonata Base >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 55 (Airbag Modules And Clock Spring (HEV)) >> Driver Airbag (DAB) Module And Clock Spring >> Repair Procedures >> Removal

Repair Procedures: Removal

WARNING: This page is about a different variant/trim than selected.
  1. Disconnect the battery negative cable and wait for at least three minutes before beginning work.
  2. Remove the driver airbag module from the steering wheel after pressing the snap fit pin stopper.
    Fig 1: Locating Snap Fit Pin Stopper
    G12061644Courtesy of HYUNDAI MOTOR AMERICA
  3. Remove the wiring fixing clip (C) and disconnect the horn connector (A).
    Fig 2: Locating Driver Airbag Module Connector, Wiring Fixing Clip And Horn Connector
    G12061645Courtesy of HYUNDAI MOTOR AMERICA
  4. Release the connector locking pin, then disconnect the driver airbag module connector (B).
    CAUTION:
    • The removed airbag module should be stored in a clean, dry place with the pad cover facing up.
  5. Disconnect the clock spring and horn connector, then remove the clock spring.
Fig 3: Locating Clock Spring And Horn Connector
G12061646Courtesy of HYUNDAI MOTOR AMERICA
scientia non olet · About Mike's Workshop Manuals