Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Hyundai >> 2017 >> Santa Fe XL Base >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (4WD Control System Diagnosis) >> DTC P1836: Bleed Pressure Line Test Error >> Verification Of Vehicle Repair

Verification Of Vehicle Repair

WARNING: This page is about a different variant/trim than selected.

After a repair, it is essential to verifying that the fault has been corrected.

  1. Connect GDS and select "Diagnostic Trouble Codes (DTC)"  mode.
  2. Using GDS, Clear DTC.
  3. Operate the vehicle within DTC Enable conditions in General information.
  4. Are any DTCs present?

    YES 

    • Go to the applicable troubleshooting procedure.

    NO 

    • System is performing to specification at this time.
scientia non olet · About Mike's Workshop Manuals