Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Hyundai >> 2017 >> Santa Fe XL Base >> Repair and Diagnosis >> Brakes >> Traction Control >> Electronic Stability Control (ESC) System >> Yaw-Rate And G Sensor >> Repair Procedures >> Removal

Repair Procedures: Removal

  1. Remove the ignition key from the vehicle.
  2. Disconnect the battery negative cable and wait for at least three minutes before beginning work.
  3. Remove the floor console.

    (Refer to "FLOOR CONSOLE ASSEMBLY ")

  4. Loosen the bolts and then remove the rear air vent duct (A).
    G12033354Courtesy of HYUNDAI MOTOR AMERICA
  5. Pull up the lock, of the SRSCM connector, the disconnect the connector (A).
    G12033355Courtesy of HYUNDAI MOTOR AMERICA
  6. Remove the SRSCM mounting bolts (3EA) from the SRSCM, then remove the SRSCM.
    CAUTION: You must remove or install SRSCM or other SRS components with the ignition switch OFF to avoid accidental airbag deployment.
scientia non olet · About Mike's Workshop Manuals