Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Hyundai >> 2017 >> Santa Fe Sport Base, AWD >> Repair and Diagnosis >> Electrical >> Body Electrical >> Body Control Module Diagnosis >> DTC B1609-00: CAN Time-Out SJB, FSJB >> DTC Inspection >> GDS Data Analysis

GDS Data Analysis

  1. Connect GDS.
  2. IG "ON" and engine "OFF".
  3. Select "DTC Analysis" mode.
  4. After erase DTC, keep the vehicle condition within the enable conditions (Refer to "DTC DETECTING CONDITION " table).
    Fig 1: Scantool Display - DTC
    G12052837Courtesy of HYUNDAI MOTOR AMERICA
  5. Is the same DTC occurred again?

    YES 

    • Go to next procedure.

    NO 

    • Fault is intermittent caused by poor contact in BCM's and/or SJB's connector or was repaired and BCM memory was not cleared. Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage. Repair or replace as necessary and then go to "Verification of Vehicle Repair " procedure.
scientia non olet · About Mike's Workshop Manuals