Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Hyundai >> 2017 >> Santa Fe Sport Base, AWD >> Repair and Diagnosis >> Accessories & Equipment >> Drivers Assistance Systems - ADAS >> Blind Spot Detection System >> Blind Spot Detection Unit >> Repair Procedures >> Installation

Repair Procedures: Installation

  1. Install the BSD unit and bracket.

    Tightening torque: 

    BSD bracket: 6.8 - 10.8 N.m (0.7 - 1.1 kgf.m, 5.0 - 8.0 lb-ft)

    BSD unit: 2.5 N.m

  2. Install the rear bumper.
  3. Connect the negative (-) battery terminal.
    NOTE: Take care not to confuse left side (master) and right side (slave) unit when installing.
    BSD units connector connect to the wiring connector.
    Item Left (Master) Right (Slave)
    Shape
    G12055083
    G12055084
    Remarks Check the bracket
scientia non olet · About Mike's Workshop Manuals