Repair Procedures: Removal

Turn the ignition switch OFF and disconnect the battery negative (-) terminal.
Remove the air cleaner assembly.
(Refer to Engine Mechanical System - "AIR CLEANER ")
Remove the intercooler inlet pipe & hose assembly.
(Refer to Engine Mechanical System - "INTERCOOLER ")
Disconnect the EWGA connector (A).

Fig 1: Disconnecting EWGA Connector
Courtesy of HYUNDAI MOTOR AMERICA
Remove the exhaust manifold heat protector (A) installation bolts.

Fig 2: Removing Exhaust Manifold Heat Protector Installation Bolts
Courtesy of HYUNDAI MOTOR AMERICA
Remove the shaft link assembly (B) after removing the C-ring (A).

Fig 3: Removing Shaft Link Assembly
Courtesy of HYUNDAI MOTOR AMERICA
Remove the EWGA after removing the bolts (A).
Electric Waste Gate actuator mounting bolt:

11.8 - 13.7 N.m (1.2 - 1.4 kgf.m, 8.7 - 10.1 lb-ft)

Fig 4: Removing EWGA Bolts
Courtesy of HYUNDAI MOTOR AMERICA
CAUTION:
- When carrying the turbo charger, do not hold the rod of the turbo charge to prevent bending the rod.