Repair Procedures: Removal

Disconnect the negative (-) battery terminal.
Remove the rear bumper.
(Refer to - "REAR BUMPER ")
Remove the BSD unit (A) after loosening the mounting nuts.

Fig 1: Locating BSD Unit With Mounting Nuts (1 Of 2)
Courtesy of HYUNDAI MOTOR AMERICA

Fig 2: Locating BSD Unit With Mounting Nuts (2 Of 2)
Courtesy of HYUNDAI MOTOR AMERICA
NOTE:
- Take care not to damage the bracket when removing the BSD sensor.
Replace the bracket (A) after loosening the nuts when the bracket is physically changed or damaged.

Fig 3: Locating Bracket With Nuts
Courtesy of HYUNDAI MOTOR AMERICA
CAUTION:
- Radar does not work normally if the bracket is physically changed or damaged.
Replace the extension wiring (A) when damaged.

Fig 4: Locating Extension Wiring
Courtesy of HYUNDAI MOTOR AMERICA