Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Hyundai >> 2017 >> Elantra Sport, Automatic DCT Trans >> Repair and Diagnosis >> Transmission >> Transmission Control Systems >> Dual Clutch Transmission Control System - 1.6L >> Input Shaft Speed Sensor 2 >> Repair Procedures >> Removal

Repair Procedures: Removal

  1. Remove the air cleaner assembly and air duct.

    (Refer to Engine Mechanical System - "AIR CLEANER ")

  2. Remove the battery and tray.

    (Refer to Engine Electrical System - "BATTERY ")

  3. Remove the ECM.

    (Refer to Engine Control System - "ECM ")

  4. Remove the clutch actuator assembly.

    (Refer to Dual Clutch Transmission Control System - "CLUTCH ACTUATOR ASSEMBLY ")

  5. Disconnect the input shaft speed sensor (A).
    Fig 1: Disconnecting Input Shaft Speed Sensor
    G12025821Courtesy of HYUNDAI MOTOR AMERICA
  6. Remove the input shaft speed sensor after removing the bolt (A-2ea).
    Fig 2: Removing Input Shaft Speed Sensor Bolt (1 Of 2)
    G12025822Courtesy of HYUNDAI MOTOR AMERICA
    Fig 3: Removing Input Shaft Speed Sensor Bolt (2 Of 2)
    G12025823Courtesy of HYUNDAI MOTOR AMERICA
scientia non olet · About Mike's Workshop Manuals