Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Hyundai >> 2017 >> Elantra SE, Standard Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 29 (Automatic Transaxle Control System - 2.0L) >> Line Pressure Control Solenoid Valve >> Repair Procedures >> Inspection

Repair Procedures: Inspection

WARNING: This page is about a different variant/trim than selected.
  1. Turn off the ignition switch.
  2. Remove the battery and tray.
  3. Disconnect the solenoid valve connector (A).
    Fig 1: Disconnecting Solenoid Valve Connector
    G12025307Courtesy of HYUNDAI MOTOR AMERICA
  4. Measure the resistance between solenoid valve signal terminal and ground terminal.
  5. Check that the measured resistance is within the specification.
scientia non olet · About Mike's Workshop Manuals