Repair Procedures: Installation
CAUTION:
Be sure to install the harness wires so they will not pinch or interfere with other parts.
- Remove the ignition key from the vehicle.
- Disconnect the battery negative cable, and wait for at least three minutes before beginning work.
- Install the seat belt buckle switch.
Tightening torque:
39.2 ~ 53.9 N.m (4.0 ~ 5.5 kgf.m, 28.9 ~39.8 lb-ft)
- Install the front seat assembly.
(Refer to Body - "FRONT SEAT ")
- Reconnect the battery negative cable.
- After installing the seat belt buckle switch, confirm proper system operation:
- Turn the ignition switch ON; the SRS indicator should be turned on for about six seconds and then go off.