Control Circuit Inspection
■ Check short to ground in harness
- IG "OFF" and disconnect CCV connector and PCM connector.
- Measure resistance between control terminal of CCV harness connector and chassis ground.
Specification: Infinite
- Is the measured resistance within specification?
YES
- Go to "Check open in harness" as follows.
NO
- Repair short to ground in harness, and go to "Verification of Vehicle Repair " procedure.
■ Check open in harness
- IG "OFF" and disconnect CCV connector and PCM connector.
- Measure resistance between control terminal of CCV harness connector and CCV control terminal of PCM harness connector.
Specification: Below 1Ω
- Is the measured resistance within specification?
YES
- Go to "Component Inspection " procedure below.
NO
- Repair open in harness, and go to "Verification of Vehicle Repair " procedure.