Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Hyundai >> 2017 >> Azera Base >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System Diagnosis (1 Of 3) >> DTC P0117: Engine Coolant Temperature Circuit Low Input >> W/Harness Inspection >> Signal Circuit Inspection

Signal Circuit Inspection

■ Check voltage 

  1. IG "OFF" and disconnect ECTS connector.
  2. IG "ON"
  3. Measure voltage between signal terminal of ECTS harness connector and chassis ground.

    Specification:  Approx. 3.3V

    Fig 1: Measuring Voltage Between Signal Terminal Of ECTS Harness Connector And Chassis Ground
    G12087547Courtesy of HYUNDAI MOTOR AMERICA
  4. Is the measured voltage within specification?

    YES 

    NO 

    • Go to "Check short to ground in harness" as follows.

■ Check short to ground in harness 

  1. IG "OFF" and disconnect ECTS connector and PCM connector.
  2. Measure resistance between signal terminal of ECTS harness connector and chassis ground.(Measurement "A")
  3. Measure resistance between signal and ground terminals of ECTS harness connector.(Measurement "B")

    Specification:  Infinite

    Fig 2: Measuring Resistance Between Signal Terminal Of ECTS Harness Connector And Chassis Ground (Measurement A)
    G12087548Courtesy of HYUNDAI MOTOR AMERICA
    Fig 3: Measuring Resistance Between Signal And Ground Terminals Of ECTS Harness Connector (Measurement B)
    G12087549Courtesy of HYUNDAI MOTOR AMERICA
  4. Is the measured resistance within specification?

    YES 

    NO