Monitor Scantool Data

■ Check parking position switch status 

1. Connect scantool with diagnostic connector.
2. Check current data with scantool.
3. Check "Shift lever P position" parameter on current data.
4. Check that data is appropriately changeable according to the shift lever position in P or others.

   Specification: 

   P position: ON

   Not in P position: OFF

   Fig 1: Scantool Display - Shift Lever P Position Parameter On Current Data

   Courtesy of HYUNDAI MOTOR AMERICA
5. Is the shift lever P position normal?

   YES 

   • Check poor connection between harness connector and Parking Position switch or Smartkey Module.

   : Thoroughly check the looseness, poor connection, bent, corrosion, contamination, deformation or damage of connector. Repair or replace as necessary and then, go to "Verification of Vehicle Repair " procedure.

   NO 

   • Go to "Terminal And Connector Inspection " procedure below.