PODS-F Zeroing Procedure

You should perform PODS-F Re-zero procedure after service or replacement about all part of the passenger seat. (Not included full seat assembly)

1. Ignition "OFF", connect GDS.
2. Ignition "ON" & Engine "OFF", select Airbag system and "PODS-F Reset" mode.

   Courtesy of HYUNDAI MOTOR AMERICA

3. The GDS will show the two PODS-F Zeroing function steps.
   1. Erase PODS-F diagnostic codes.
   2. PODS-F initialization.

   Courtesy of HYUNDAI MOTOR AMERICA

   CAUTION: This step must be done PODS-F re-zero, when the front passenger seat is empty.
4. The PODS-F initialization procedure will be performed.

   Courtesy of HYUNDAI MOTOR AMERICA

   Courtesy of HYUNDAI MOTOR AMERICA

   CAUTION: Erase the SRSCM diagnostic codes after completing the PODS-F zeroing.
   NOTE: In case of zeroing failure

   • Code 01: Requestor ID out of range.
   • Code 02: ECU faults.
   • Code 03: ODS sensor short to ground.
   • Code 04: Open between ODS ECU and mat.
   • Code 05: ODS ECU has not been trimmed.
   • Code 06: Configuration disabled in ECU calibration.
   • Code 07: Configuration value out of range.
   • Code 08: Used in zero Request response only.
   • Code 09: Algo enabled this ignition cycles.
   • Code 0A: Upper offset value created during the zero process.
   • Code 0B: Lower offset value created during the zero process.
   • Code 0C: Voltage diagnostic
   • Code 0D: The delta of QX_Freq_Low and QX_Freq_High must remain low.
   • Code 0E: Temperature is above O deg C during the zero process.
   • Code 0F: Re-read QX Final compare delta limit. (zero verify)